Jamming

How to play a Dobro break in a bluegrass jam

Published · Updated · 5 min read · By Mary Jane Howie

A break is your solo turn. The singer finishes a verse or a chorus, and the leader nods at you. You play the melody for one pass while the circle backs you up. On Dobro, a break is the tune played with the bar, with slides into the main notes and a steady right hand. Know the key, find the bar positions, start on the beat, and finish on the 1 chord.

Get the key before the song starts

Ask the leader for the key. Most bluegrass Dobro players tune to open G, which is G, B, D, G, B, D from low to high. Strum the open strings and you hear a G chord. That makes G the easiest key.

In open G, the bar laid straight across a fret plays a major chord. Fret 5 is a C chord. Fret 7 is a D chord. Fret 12 is G again. These are the bar positions for the chords in the keys you will hear most:

Key of G: G at the open strings, C at fret 5, D at fret 7.

Key of A: A at fret 2, D at fret 7, E at fret 9.

Key of D: D at fret 7, G at the open strings, A at fret 2.

Key of C: C at fret 5, F at fret 10, G at the open strings.

What keys bluegrass jams use most often lists the keys you will hear at most circles.

Guitar players often use a capo for the singer’s range. The capo changes the key you hear, so ask for the sounding key and not the chord shapes. How to use a capo in a bluegrass jam explains the difference.

Know when your turn comes

The leader sets the order. After the first verse or chorus, the leader says “Dobro” or points at you. Some circles go to the fiddle first, and some go to the banjo. Watch the leader as the singer reaches the last line.

A break is not a kick-off. A kick-off is the short intro before the first verse. Your break comes after the first vocal. How to take a break in a bluegrass jam covers the turn order in more detail.

Switch from backup to melody

Before your turn, you play backup. That may be soft fills between the singer’s lines or long, quiet chords under the vocal. How to play Dobro backup in a bluegrass jam covers each one.

When your break starts, switch to the melody. Make the change on the first beat of the new bar. The guitar and bass keep the rhythm going, so a clean switch needs no gap.

Play the melody the singer sang

Keep your first break simple. Play the tune as the singer sang it, in the same rhythm. The circle can follow a plain melody. A fancy break that loses the tune loses the circle.

Find the melody notes on the top strings first. Keep the bar near the chord position for the bar you are in. Move to the next position when the chord changes. If you lose the melody, play a note from the current chord and find the tune again at the next chord change. How to hear chord changes in a bluegrass jam helps with this.

Slide into the notes

The slide is the Dobro sound. Start the bar one or two frets below a target note and slide up into it. Land on the fret and stop the bar there. A bar that wobbles past the fret sounds out of tune.

Slide into the long notes at the end of a phrase. Play the quick notes straight. Add one or two slides per break. A slide into every note sounds the same from start to finish.

Tilting the bar, called a slant, lets the bar touch two strings at different frets. It gives you notes from outside the chord position without a jump. Learn slants after the plain melody feels steady.

Use your right hand

Most Dobro players pick with a thumbpick and two fingerpicks. Use rolls under the melody to fill the space between notes, much like a banjo player does. Banjo rolls to learn first for bluegrass shows patterns that carry over to Dobro.

Mute the strings you do not want to ring. Rest the fingers of your left hand lightly on the strings behind the bar. Use the heel of your right hand near the bridge to stop notes. Clean stops make the melody easy to hear.

Play out, but listen

A banjo and a flat-top guitar can cover a Dobro. A break needs more attack than backup does. Pick closer to the bridge for a sharper tone, and dig in with the thumb on the melody notes.

At a loud campground circle, play with more force. At a quiet slow jam, ease back. How to jam at a bluegrass festival campground describes the noise level at a big circle.

Finish on the 1 chord

A break lasts as long as the verse or chorus it replaces. Count the bars from the singer’s pass. At the last chord change, bring the melody home to the 1 chord. In G, that is the open strings or fret 12.

On the last beat, look at the next player and nod. Then drop back to backup. The break is over when the next player starts, not when you stop. If the singer comes back in after your break, play softer.

Tunes for a first Dobro break

Choose tunes with a simple melody and few chords. These public domain songs come up in jams:

Will the Circle Be Unbroken: often called in G. See Bluegrass gospel songs for a jam for more like it.

Amazing Grace: often called in G. It works in 3/4 time at a slow jam.

Cripple Creek: often called in A and also played in G.

Old Joe Clark: often called in A. It has a flat 7, so read Old Joe Clark, Red Haired Boy, and the flat 7 first.

Soldier’s Joy: often called in D.

Players to hear

Listen to Josh Graves for the sound that brought the Dobro into bluegrass. Listen to Jerry Douglas for a modern approach. The full list of players sits on the Bluegrass Dobro page.

Pass when you need to

If you do not know the tune, wave off the break. The circle will move to the next player. Pass this time, and listen for the chord changes. A clean pass is better than a break that stalls.

← Back to home